Uninterruptible Power Supply (UPS) Systems Electrical – BALIKPAPAN



1th – 4th November 2011


Grand Senyiur Hotel, at Ars Muhammad No 7, Balikpapan Kalimantan Timur.


IDR 7.000.000,- For sending 3 participant from the same company IDR 6.500.000,-/participant NON RESIDENCIAL.


Ir. Teguh Santoso
Prof. Dr. Ir. Hamzah Berahim, MT


This technical course begins with a discussion of the need for UPS systems. It then covers the relative comparisons between various UPS topologies and their modes of operation. The batteries used for UPS systems are covered next. How a battery works, their maintenance, safety and testing is throughly discussed.

A solid working knowledge of the typical electrical components found within a UPS is developed before exploring how AC is converted to DC and then inverting DC back to AC. When all of the above elements of a UPS are understood, a theoretical rectifier and inverter feedback loop are throughly discussed. This will be followed by a trouble shooting exercise. Students are given failure scenarios where they work in groups to find which circuit component has opened, shorted or significantly changed in value to produce the alarm condition described. The course finishes with a general discussion on UPS system trouble shooting.

Some working knowledge of basic electrical engineering principles is required, although this will be revised at the beginning of the course. Real-life experience in working with batteries and UPS systems will enable the workshop to be placed in context.

Who Should Attend:
This course is recommended for:

– Electrical Engineers
– Electrical Maintenance Tradespeople & Technicians
– Instrumentation and Control Engineers
– Power System Protection and Control Engineers
– Building Service Designers
– Data Systems Planners and Managers
– Other electrical personnel involved in the maintenance industrial, commericial and institutional power systems.

Course Outline:

I. Introduction to UPS Systems
* Power conditioners
* Uninterruptible power systems
* Power quality source alternatives
* Power disturbance cost comparisons
II. Three General Types of UPS’s
* Kinetic (Motor Generator Sets)
* Flywheel
* Static and Components
* Rectifier
* Batteries
* Inverter
III. Three types of Static UPS’s
* Traditional UPS
* Static UPS
* Static UPS with Bypass
IV. UPS Operation Overview
* The Need for UPS System
* Power System Disturbances
* Basic Type of UPS Systems
V. Introduction to Batteries
* Primary Batteries
* Secondary Batteries
VI. Lead Acid Batteries
* Chemistry
* Different types
* Capacity Factors
* S-Curves
* Battery Safety and Maintenance
* Float and Equalize Voltages
* Load Testing
VII. Nickel Cadmium Batteries
* Chemistry
* Battery Types
* Capacity Factors
* Battery Safety and Maintenance
* Float and Equalize Voltages
* Load Testing
VIII. Passive Electronic Components
* Resistors Circuits
* Capacitor Circuits
* Inductor Circuits
IX. Semiconductors
* Diodes
* SCR’s
* Transistors
X. Logic Gates
* AND/NAND Gates
* OR/NOR Gates
* Inverter Gate
* D Type Flip Flop
* XOR/XNOR Gates
XI. Operational Amplifiers
* Inverting Op Amp
* Non-inverting Op Amp
* Differential Op Amp
* Unity Gain Op Amp
* Summing Op Amp
* Integrating Op Amp
* Comparator Op Amp
XII. AC to DC Conversion
* Full Bridge
* Three Phase
* Six Pulse
XIII. DC to AC Inversion
* Quasi Square wave
* PWM waveform
XIV. UPS System Overview
* Rectifier Stage
* Inverter Stage
XV. UPS System Troubleshooting
* Basic Use of Test Equipment
* Rectifier Troubleshooting
* Inverter Troubleshooting


Ketik SMS dengan format :
-kirim ke 085286451074

Contoh :
DAFTAR TRAINING ISO#2Mei2011#ARIEF#Company#3#nama@email.com


Print This Post Print This Post Email This Post Email This Post

Cara cepat dan mudah Registrasi online di Informasi seminar 21. Mencari jadwal seminar dan training atau request in-house training online.


Comments are closed.

Post Navigation